C-Silicone Rubber Base Impression Material
Zetaplus: Polysiloxane
for the first impression characterized by initial flow in the working phase and
high rigidity after hardening. Recommended for the two stage technique (double
impression)
Zetaplus
Soft: Polysiloxane for the first impression characterized by
initial flow in the working phase and adequate elasticity on removal from the
oral cavity. Recommended for the two stage technique (double impression)
*Oranwash
VL: Low viscosity, extremely fluid, hydrocompatible, polysiloxane.
Recommended for the two stage technique (double impression)
*Oranwash
L: Low viscosity, extremely fluid, hydrocompatible, polysiloxane.
Recommended for the two stage technique (double impression)
CHARACTERISTICS
- High initial flowability and excellent rigidity after
hardening for the putties
- Thixotropy for the washes
- High tear resistance
Advantages
- Excellent relation between rigidity and elasticity
- Ideal working time/setting time
ratio
- High flowability and accuracy of
wash materials
- Putty and wash materials with the
same catalyst
TECHNICAL SPECIFICATIONS:
Type
of setting | Normal
Set |
Working | 1:15 |
Time
in | 3:15 |
Setting
time* | 4:30 |
ISO
4823 | Type
0 Putty Consistency |
Strain | 2 - 5
% |
Elastic | >
98 % |
Linear
dimensional | <
0.2 % |
PACKAGING
- 1 900 ml tub 900 ml (1.53 kg)
- 1 x 140 ml Oranwash VL
- 1 x 60 ml Indurent Gel
Direction to Use
- Use the measuring spoon to dose the required quantity
of Zetaplus and spread it out over your hand (note: for the correct dosage
the putty should be level with the top of the measuring scoop). Press the
rim of the measuring scoop onto the putty once for each measure dosed. For
each measure of material, apply two strips of Zhermack Indurent Gel as
long the measuring scoop (4 cm.)
- When using Zhermack Indurent
Liquid, dose 5 – 6 drops of hardening liquid for each scoop of putty used.
Mixing:
- Fold and knead the putty energetically with your
fingertips for about 30 sec., until the colour is even, without any
stripes
- Spread out the putty over the
impression tray. The working time including mixing time is about 1 min. 15
sec.
- Put into the mouth and wait until
it is set, which will take about 3 min. 15 sec.